Brother-brother-sons Ledonardo1 Ver. 2 Instrukcja Użytkownika

LEDONARDO 1 BROTHER, BROTHER & SONS ApSUSER MANUALuser manual rev. 1.06

USER MANUAL9LEDONARDO 1WWW.BROTHERS-SONS.DKRaise the LED assembly approx. 5 mm / 0,2” by inserting e.g. a screwdriver in both ends.Lower the Main hous

USER MANUAL10LEDONARDO 1WWW.BROTHERS-SONS.DKINSTALLATIONDo not operate the product if the ambient temperature exceeds 35° CProvide a minimum clearance

USER MANUAL11LEDONARDO 1WWW.BROTHERS-SONS.DKAC PowerDMX Data linkThis fixture must be connected to ground.Electrical:AC Power: 100 – 240 V nominal, 50

USER MANUAL12LEDONARDO 1WWW.BROTHERS-SONS.DK8 8 8 8 8 8DMX present indicator8 bit IndicatorNote: Beware, when using Strobe Lenght, that if the Strobe

USER MANUAL13LEDONARDO 1WWW.BROTHERS-SONS.DKSOFTWARE MENUDefault values indicated by bold fontAddr 1 DMX adress value 1 - 512Mode Resolution 8 bi

USER MANUAL14LEDONARDO 1WWW.BROTHERS-SONS.DKSOFTWARE MENUDefault values indicated by bold font Log Max Fan Maximum fan speed logged. (in RPS) -

USER MANUAL15LEDONARDO 1WWW.BROTHERS-SONS.DKSPECIFICATIONSPhysical: Depth: 210 mm / 8,27” (additional depth when mounted 0 mm / 0”)Width: 220 mm /

USER MANUAL1LEDONARDO 1WWW.BROTHERS-SONS.DKINTROBrother, Brother & Sons ApS - The information in this manual is subject to change without notice.G

USER MANUAL2LEDONARDO 1WWW.BROTHERS-SONS.DKCONTENTSIntro...

USER MANUAL3LEDONARDO 1WWW.BROTHERS-SONS.DKSAFETYSafety Notice:It is important to read ALL safety information and instructions in this manual before i

USER MANUAL4LEDONARDO 1WWW.BROTHERS-SONS.DK314 mm / 12,36”444 mm / 17,48”276 mm / 10,87” 294 mm / 11,57”PRODUCT OVERVIEWCompleteLEDonardo 1 - LED Ligh

USER MANUAL5LEDONARDO 1WWW.BROTHERS-SONS.DKPhillips PH2 screwdriverAllen/Umbraco key size 2Slotted srewdriver size 3-3,5Tools needed to perform the co

USER MANUAL6LEDONARDO 1WWW.BROTHERS-SONS.DKUnscrew the four screws as illustrated.Note: You need to turn the lamp housing 90º when taking it out.12Usi

123USER MANUAL7LEDONARDO 1WWW.BROTHERS-SONS.DK1. Remove the two screws holding the cable strain relief and pull the cable thorugh the side of the lamp

WirepulleyUSER MANUAL8LEDONARDO 1WWW.BROTHERS-SONS.DKNote: Remember to insert the guide bar with the correct orientation.Place the LED / Heatsink part